If you’re experiencing Windows installation errors using the BIOS recovery process, here’s a step-by-step guide to help you troubleshoot and fix these issues:
Preparation
- Ensure your system is in the correct boot order and has the latest drivers installed.
- Make sure your system has a stable power supply and is not running from an external battery.
Step 1: Enter BIOS Setup (F2 or F12 key)
- Restart your computer and immediately press the key that corresponds to the BIOS setup (F2, F12, or Del).
- If you’re unable to find the correct key, refer to your motherboard manual.
- Once in BIOS setup, look for an option labeled “Boot Order” or “Boot Configuration.”
- Set the boot order to prioritize your Windows installation over any other operating systems.
Step 2: Check System Logs
- Enter the Command Prompt (Command Prompt) by pressing the key you used for entering BIOS setup.
- Type
dism.exe /online /cleanup-image /restorehealthand press Enter.
- This command will scan your system for updates and repair any issues that might be causing the installation error.
Step 3: Run System File Checker (SFC)
- Open Command Prompt again by pressing the key you used to enter BIOS setup.
- Type
sfc /scannowand press Enter.
- This command will scan your system for corrupted files and repair any issues that might be causing the installation error.
Step 4: Run DISM (Deployment Image Servicing and Management)
- Open Command Prompt again by pressing the key you used to enter BIOS setup.
- Type
dism.exe /online /cleanup-image /restorehealthand press Enter.
- This command will scan your system for updates, repair any issues that might be causing the installation error, and remove corrupted files.
Step 5: Run System Restore
- Open Command Prompt again by pressing the key you used to enter BIOS setup.
- Type
sccmcl.exe(for Windows 10) orvssadmin(for Windows 8/8.1/7) and press Enter.
- This command will restore your system to a previous point when it was working properly.
Step 6: Reboot and Try Again
- Once you’ve completed all the above steps, reboot your system and try installing Windows again.
Common Issues and Solutions
- No boot device: Ensure that your Windows installation is on a physical drive (such as C:) or a network location.
- Windows cannot find the file: Check if the file path is correct and ensure that the file exists in the correct location.
- Installation failed due to UEFI issues: Try using the Legacy Boot Option in UEFI settings or disable Secure Boot and use the UEFI firmware override.
Additional Tips
- Make sure to save your system configuration and restore points regularly to prevent data loss in case of a boot error.
- Consider consulting your motherboard manual for specific instructions on entering BIOS setup and troubleshooting BIOS-related issues.